|
The Toyota Landcruiser Owners Club Landcruiser Club - Dedicated to Toyota Landcruiser, Amazon, Colorado and Prado Owners
|
View previous topic :: View next topic |
Author |
Message |
vyas Newbie
Joined: 29 Aug 2016 Posts: 9 Location: HARARE
|
Posted: Mon Aug 29, 2016 9:32 Post subject: knocking sound manual transmission |
|
|
Hello
i have a 1997 land cruiser Prado 1kz-te engine model KD-KZJ95 with manual transmission.There is a knocking or tapping sound coming from the gearbox,when the clutch is pressed in ideal the sound still continues after a drive . Just put in a new clutch plate, pressure plate and trust being at 200 000km which i am told is normal at that km.The knocking sound go's away when you restart the motor in ideal.Gear 3 has some trouble engaging but not all the time.Please can someone help.
Thank you |
|
Back to top |
|
|
Google Sponsor
|
Posted: Mon Aug 29, 2016 9:32 Post subject: Google Ads keep this community free to join! |
|
|
|
|
Back to top |
|
|
diggerdave ****
Joined: 03 Oct 2014 Posts: 448 Location: Bubwith
|
Posted: Mon Aug 29, 2016 12:01 Post subject: |
|
|
It's a bit unclear from your post: did this only begin after you replaced clutch? If so, it could be a rattle from an internal component such as release bearing or clutch release fork (although these would normally go away when the clutch was depressed. Was the rubber boot on the bell housing put back correctly seated? Are the hydraulic pipes to the slave cylinder touching the bell housing? _________________ 1997 KZJ90 3.0d, 2" suspension lift, 235/85/16 Cooper STT Pros. 217k hard miles |
|
Back to top |
|
|
vyas Newbie
Joined: 29 Aug 2016 Posts: 9 Location: HARARE
|
Posted: Thu Sep 01, 2016 13:14 Post subject: |
|
|
diggerdave wrote: |
It's a bit unclear from your post: did this only begin after you replaced clutch? If so, it could be a rattle from an internal component such as release bearing or clutch release fork (although these would normally go away when the clutch was depressed. Was the rubber boot on the bell housing put back correctly seated? Are the hydraulic pipes to the slave cylinder touching the bell housing? |
Hi thank you will have a look. |
|
Back to top |
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|